Latest Announcemnent
New thread

USB Did not recognised

Status
Not open for further replies.
Z

[Z][E][U][S]

Active Member
269
2010
2
0
Guys this is getting really annoying whenever i plugin my pendrive a pop up comes out throwing message USB did not recognised i tried many ways to solve it but nothing worked.:(

Plz help me out to solve this problem...:'(
 
10 comments
may be your pendrive gone bad.......me too got this problem and get it replaced at service centre.....may be some over voltage problem.......did u tried plug it in another PC.....if then also same msg popup,then it will be sure the problem is with the pendrive
 
Shut down your computer ...... remove the plug from Power Supply and give some rest to MotherBoard for 5 minutes...... Then, start your PC again. Now, plug your Pen drive and start data transfer. thats it.
 
Simply UNPLUG YOUR COMPUTER FROM THE POWER SUPPLY. Yes that’s it! Note that this does not mean just turning off your computer because modern computers don’t really turn off when you press the power button as the motherboard still gets power.

First to explain, the motherboard is where all of hardware of the computer is connected to, including the USB ports. Sometimes the motherboard needs to be “rebooted” also because something can go wrong, i.e. all your USB ports suddenly stop working. The small microprocessor on the motherboard will reload the drivers and your USB ports should be back to recognizing all devices!

So first turn off your computer using Shut Down or pressing the power button and then UNPLUG it from the wall outlet. Let it sit for about a minute and then plug it back in.
 
Status
Not open for further replies.
Back
Top